Why Does My Garage Door Track To One Side

Thanks for the quick response.

Why does my garage door track to one side. Misaligned tracks misaligned tracks are another common cause for a garage door going off track. The track should be tighter at the bottom then at the top if it is tight enough at the bottom the door will always close in the same position. Maybe someone bumped into it recently. The span from rail to rail is about 1 2 3 4 off but i guess that should be okay.

Bent tracks on your garage door need immediate repair to get the door working properly. Yeah that was it. If you ve had your door for a while or are in and out of it a lot it can easily end up out of alignment. Bottom of the door is up on one side.

Move the bottom of the track on the right closer to the door so it can t shift back. It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw. By pushing the door back into position you should have made the vertical track straighten. The front measured 15 and the back measured 16 from the wall.

Most track damage happens to the vertical tracks that attach to the wall of the garage door opening. With misaligned tracks the risk of the rollers coming off the tracks gets much higher. Changed them to be the same and now the cables are equal and the track isn t hitting the door. I had a garage door company here that told me my garage door needs to be balanced and showed me how it would not stay up by itself when door is not engaged.

Or it could just be that the hardware has become loose over time. Push the door back to adjust the door and get the center aligned again. The door runs are housed in a garage door track one on each side of the garage door. One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door.

Your door has simply shifted to one side. This usually happens when the bolts holding the horizontal tracks get loose causing the bracket to wobble at the slightest unnatural vibrations of the door. The vertical tracks should be in a slight v instead of being plumb up down. Garage door shifts to one side.

With the door propped open take the s hook out of the support and tighten or loosen the cable as needed. The cable is attached to the door and runs to an s hook that attaches to the track support.